Description
Handle Made in the USA!
Make power feed actuation a breeze! Upgrade the short and hard to use power feed lever on your 9×20 and 9×19 lathes with this ergonomic handle! The original handle on these lathes is uncomfortable and hard to actuate at best, at worst you may find your hand slips off the handle when trying to stop the power feed at an exact point. This upgraded handle solves those problems by offering a smooth and ergonomic handle that allow for easy actuation of the power feed lever. The handle has an ABS plastic outside and uses a hardened bolt as the main structural support shaft (similar concept to a screwdriver) for maximum strength, good weight, and feel.
This handle is available in 3 sizes: 70mm (original handle length but provides ergonomic upgrades), 90mm, and 110mm.
Note: This handle is threaded M8-1.25 and will work on most of the import 9×19 and 9×20 lathes power feed handle. If your lathe has a different thread pitch please reach out as I can make you a handle for your lathe easily! You may find that these handles may also work for other handles on your lathe besides just as a power feed lever.
One Upgraded handle only! Lathe, additional handles, tools, etc. are NOT included and are shown in photos for illustration purposes only. All dimensions given in this listing are approximate
Reviews
There are no reviews yet.